|
|
|
|
• Does not slump
• Cleaned surfaces can be sealed again
• Usable on vertical, horisontal and angled surfaces
• Removes mould from old joint gaps
• It is recommended in restauration and refurnishing |
|
|
|
|
| It is used for the removal of hardened silicone. |
|
|
|
|
|
| Colour |
white, slight yellow/pink |
| Appearance |
paste with small grains |
| Specific gravity |
850 kg/m3 |
| Viscosity |
paste-like |
|
|
|
|
|
First mechanically remove as much of the silicone sealant as possible. Then add Tekapursil S into the joint. The thickness of the Tekapursil S must be 2-3 times the size of the remaining silicone (at least 4mm). Leave the Tekapursil S to react with the silicone at least 24 hours. It is recomended that you use the Tekapursil S on surfaces which are not visible first.
After 24 hours remove the dissolved sealant and clean the joint gaps with a cloth and water. For thicker layers the procedure should be repeated. Reaction time The time needed for the removal of the sealant depends on the surface and the thickness of the sealant. If Tekapursil is used on textile, leave it on onla for 30 minutes, because there is a danger of stain forming. |
|
|
|
|
| 110 ml tubes |
|
|
|
|
| 24 months in dry and well ventilated places at room temperature and in the originally sealed package. During storage decolouring can occur, but it does not affect the quality of the product. |
|
|
|
|
| Keep out of reach of children. Avoid contact with skin and eyes. Wear protective gloves. In case of an accident or sickness seek medical attention immediately. Can cause burns. When consumed it can cause lung damage. |
|
|
|
|
| The information supplied is accurate to the best of our knowledge and is based on reliable tests and practical experiences. Properties quoted are intended, as a guide and do not therefore constitutes a specification. You should thoroughly test any application to be sure that product corresponds to the required performances. |
|
Products by properties
